"I had the same problem some weeks ago. If the battery go down to much and Wizard switch off then you have big problems because this ppc charge only when OS is loaded!:| Yes. If I let my battery completely drain, I better have a USB cord handy that I can do some quick wirestripping on. Luckily, I happen to work in an environment that has them laying around all over the place and I got my 8125 up and running. HOWEVER. Cingular, T-Mobile? Bad form. Simply terrible. Please provide some method for charging the batteries without the OS running? Thanks.
So if you are not able to switch on to charge it you have to charge the battery outside the phone.
This problem happen to me when i was traveling and i forget my charger at home... I bought another USB cable i cut it to take out the red and black wires, then i take out the battery from the Wizard and put red wire on the pin with label (+) and black wire to the pin (-), the pin label are written on the battery. I put attention to don't make shortcuts and that wires and pin was touching and let 15 minutes to charge (natually the USB was attached to my laptop). Then disconnected USB cable from laptop, put the battery on Wizard and switched on it pressing the power button few seconds. It booted up and when OS was loaded i connected the normal USB cable to the phone to finish to charge it.
Now i charge the battery before that reach 0%!"
July 2005 August 2005 February 2006 March 2006 April 2006 May 2006 June 2006 July 2006 August 2006 September 2006 October 2006 November 2006 December 2006 January 2007 February 2007
Subscribe to Posts [Atom]